Back to the catalogue

Simple Kapla plane model

Simple Kapla plane model

Pieces

~25

Difficulty

Easy

Time

10 min

Age from

4 years

Shared by

Kaplea
Build this Kapla plane with its stepped nose and real sloping wings resting on their engines! This model is very easy to build, and comes together quickly with quite few Kapla.

Build the Kapla plane step by step

Step 1: lay the first base of the plane

Step 1: lay the first base of the plane

Lay 3 planks flat, end to end: that's the fuselage, the body of the plane. Then add one Kapla on each side, well clear of it: those are the engines, and the wings will lean on them later.

💡 Astuce : the engines are about one and a half Kapla away from the fuselage.

Step 2: build the second layer of Kapla

Step 2: build the second layer of Kapla

Lay another course of 3 planks on top of the first, but shift it slightly forward (this shift is what gives the plane its nose). Also stack a second Kapla on each engine, with no shift this time.

Step 3: finish the body of the plane (fuselage)

Step 3: finish the body of the plane (fuselage)

Build 2 more layers, still 3 Kapla each: the 3rd moves forward again by a tiny bit, and the last one comes back just above the first. The nose (the front of the plane) takes shape as a staircase.

Step 4: lay the sloping wings

Step 4: lay the sloping wings

Lay 3 planks on each side, on a slope: the top rests on the back of the fuselage, and the bottom runs down to the table, passing over its engine.

💡 Astuce : lay the middle one first, then press its two neighbours up against it.

Step 5: add the tailplane to steer the plane

Step 5: add the tailplane to steer the plane

At the back, lay one plank across the fuselage, then a second on top of the first: that's the tailplane, the part that helps the plane fly straight.

💡 Astuce : don't put it right at the back, move it slightly forward for balance.

Step 6: the last Kapla of the model, the plane's fin

Step 6: the last Kapla of the model, the plane's fin

To finish, lay one last Kapla along the axis of the plane, on top of the tailplane: that's the fin, the part that stops it from turning on its own. Your plane is ready for take-off!

Frequently asked questions

The first advantage of this build is how few wooden Kapla you need to create this plane. The model takes only 25 Kapla: 12 planks for the fuselage (the body of the plane), 4 for the two engines, 6 planks for the wings and 3 for the tailplane and fin at the back.

The 2nd advantage is that it's a very simple model to build. A child can build it alone from age 4. Laying the sloping wing planks and positioning the back of the plane correctly are the 2 trickiest moves: an adult can lend a hand the first time!

Comments

No comments yet. Start the conversation!

Leave a comment

Up to 3 photos, 5 MB each. They are resized and published once approved.

Your email address will not be published. It is only used to contact you and for moderation. You may request its deletion at any time — see the legal notice.